Cameo CLF4T Bedienungsanleitung Seite 8

DEVICE SETTINGS (Settings)
Press the encoder to access the main menu. Rotate the encoder to select the menu item "Settings" (left arrow) and confirm by pushing the
encoder. This will take you to the submenu for setting the submenu items (see table, rotate the encoder to select and push the encoder to
confirm selection). Now select the arrow symbol for "back" at the top of the submenu. Push the encoder and access the main menu in the
same way to return to the main display. The main display is activated automatically if no input is made within approximately 30 seconds.
---------------- Menu ----------------

DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
Settings
Display Reverse = Rotate display
Display Off = Display lighting
Operational status
DMX fail = with DMX signal
fault
Dimmer curve = Dimmer curve
Dimmer
= Dimmer response
response
LED PWM
LED Frequency =
frequency
Fan = Adjust fan control
Fan = Adjust fan control
Reset to factory
Factory Reset =
setting
8
Back
On Display is rotated by 180° (e.g. for overhead installation)
Off No display rotation
Back
On On permanently
Off Deactivation after approximately 1 minute of inactivity
Back
Hold Last command is retained
or blackout, Activates blackout
Full On Spotlight switches to full on
Standalone Stand alone mode is activated
Back
Linear Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX values and
Exponential
broadly adjusted at higher DMX values
Light intensity can be broadly adjusted at lower DMX values and
Logarithmic
finely adjusted at higher DMX values
Light intensity can be finely adjusted at lower and higher DMX values
S-curve
and broadly adjusted at medium DMX values
Back
LED Light responds abruptly to changes in DMX value
Halogen Light behaves like a halogen spotlight with slight brightness changes
Back
800 Hz /
1200 Hz /
2000 Hz / 3600
Configuration of LED PWM frequency
Hz /
12 kHz /
25 kHz
Back
Car Automatic fan speed control
Off Deactivated fan with greatly reduced brightness
Constant Low Constantly low fan speed with reduced brightness, if necessary
Constant Medium Constant average fan speed with reduced brightness, if necessary
Constant High Constant high fan speed
Back
Reset Now! Reset to factory settings