Motorola PMPN4632 Bedienungsanleitung Seite 17

Chapter 4
Troubleshooting
The adaptive charger incorporates the following features:
• A universal input power supply
• A constant current rapid charger
• A negative pulse conditioning charger
• A calibration unit
• A USB Type A power output
• A user selectable on or off switch for turning On/Off calibration.
The combination of the features above are unique in a desktop charger. Therefore, operation of the
radio with a battery attached while in the charger is not recommended.
During the calibration process, the battery becomes fully discharged. As a result, the radio may shut
down during calibration mode. During the charging process, radio operation may result in minimally
reduced radio performance and extended battery charge time.
When troubleshooting, always observe the color of the LED.
Table 6: Troubleshooting
Problem
No charger indication
• Charger contact is not being made.
• No power to the charger.
Blinking red indication
• Charger contact is not being made.
• Battery is not chargeable.
Blinking amber indication
• Battery is waiting to charge. The battery
temperature may be below 5 °C (41 °F),
above 40 °C (104 °F), or the battery volt-
age may be lower than the predetermined
threshold level for rapid charging.
What to do...
Check that the battery is inserted correctly.
Make sure that the power supply plug is secure-
ly plugged into the charger and an appropriate
AC outlet, and there is power to the outlet.
Remove the battery from the charger and re-
place it back into the charger.
• Verify that the battery is a Motorola Solu-
tions-authorized battery listed in
Solutions Authorized Batteries on page
Other batteries may not charge.
• Remove power from the battery charger and
using a clean dry cloth, clean the gold metal
charging contacts of both the battery and the
charger.
• Replace battery.
When this condition is corrected, the battery be-
gins charging automatically.
MN009420A01-AA
Troubleshooting
Motorola
12.
17