Veripart VPTMVR85 Bedienungsanleitung Seite 37

Recommended storage periods
For recommended food storage time, refer to the information given on
your food packaging.
Defrosting
1. When the freezer has been working for a period of time, the inner
surfaces will become covered with a layer of white frost. Because
this might increase electricity consumption and lessen the effect of
refrigeration, the freezer should be defrosted regularly.
2. When defrosting, unplug the freezer, and remove all of the food.
Either allow the frost to melt naturally, or carefully use a plastic scraper
to scrape it off. Finally, wipe away any remaining ice and water, plug
the freezer in, and return the food to it.
！ ！
Caution!
• Never use sharp, metal tools to chip ice away.
Cleaning inside the freezer
After defrosting you should clean the freezer internally with a weak solution
of bicarbonate of soda, then rinse with warm water using a damp sponge or
cloth and wipe dry. Wash removable parts in warm soapy water and ensure
they are completely dry before replacing them in the freezer. Condensation
will form on the back wall of the freezer; however, it will normally run down
the back wall and into the drain hole.
Cleaning outside the freezer
Use standard non-abrasive detergent diluted in warm water to clean the
freezer's exterior. Make sure that the doors are closed to prevent any
detergent getting on the magnetic door seal.
The grille of the condenser at the back of the freezer and the adjacent
components can be vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of
the freezer.
36