Stand Alone Operation; Dip Switch Setting - HQ Power VDPLMS1 Bedienungsanleitung

• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical
Specifications"), dust and moisture. Respect a minimum distance of 0.5 m between the device's light
output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Features
• powerful pinspot with one 3 W CREE
• automatic pan control for a 540° rotation, manual tilt
• DMX control through 5 channels with electronic dimmer and shutter
• stand-alone mode, sound-activated mode through built-in microphone
• comes with 1x extra beam lens and 4x colour lens
5. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable (e.g. VDLSC7 or
VDLSC8).
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used. Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Use
Connect the included power cord to the pinspot via the power input and insert the power plug into the
mains. Next, choose the desired operation mode.
Stand-Alone Operation
Automatic Mode
The VDPLMS1 pinspot features preset programmes which, along with the pan movement, can be
selected via the DIP switches [4].

DIP switch setting

1, 9 on
2, 9 on
3, 9 on
4, 9 on
5, 9 on
24.01.2011
All manuals and user guides at all-guides.com
VDPLMS1
®
LED
90° movement range
180° movement range
270° movement range
360° movement range
540° movement range
4
function
©Velleman nv