Stand-Alone Mode; Master/Slave Mode; Remote Control - HQ Power HQLE10029 Bedienungsanleitung

dimming
silent scene
slave
display
IR
5.3

Stand-Alone Mode

The device starts running in stand-alone mode after connection to the mains. This mode allows
you to use the device without controller.
5.4

Master/Slave Mode

• The master/slave mode allows for connecting several devices to a single master device in a
daisy chain.
• All slave devices will then work synchronously with the master device.
• Configure all slave units before connecting the master unit to the daisy chain.
5.5 DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.
• All DMX-controlled devices need a digital start address so that the correct device responds
to the signals. This digital start address is the channel number from which the device starts
to "listen" to the DMX controller. The same starting address can be used for a whole group
of devices or an individual address can be set for every device.
• When all devices have the same address, all the units will "listen" to the control signal on
one particular channel. In other words: changing the settings of one channel will affect all
devices simultaneously. If you set individual addresses, each device will "listen" to a
separate channel number. Changing the settings of one channel will only affect the device
in question.
Refer to page 3 of this manual for the DMX channel values.
5.6

Remote Control

Black Out
Press this button to black out the current active mode. Press again to return.
Auto
1. Press <AUTO> to enable the auto mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <AUTO> to disable.
Sound
1. Press <SOUND> to enable the sound mode.
2. Press <+> or <-> to choose the different programmes.
3. Press <SOUND> to disable.
V. 01 – 07/12/2020
HQLE10029
dIMM dI1-dI9
SILE on/oFF
SLAV Slave
dISP
dISP
dSIP
InFr on/oFF
9
master dimming
closed/open light when no music in sound
mode
slave mode
normal display
inverted display
IR remote signal reception enabled/disabled
©Velleman nv