Stand-Alone - HQ Power VDPLW108 Bedienungsanleitung

Channel
4
5
6
c. DMX512 Connection
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDPLW108. Multiple VDPLW108s can be linked through serial linking. The linking cable should
be a two-core screened cable with XLR input and output connectors.
d. DMX512 Chain with Termination
e. DMX512 Start Address
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDPLW108.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDPLW108s will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 6-channel VDPLW108, you will have to set the start address of the first VDPLW108 to 1, the
second VDPLW108 to 7 (1 + 6), the third to 13 (7 + 6) and so on.
f. Stand-Alone
Code On
1
2
3
4
5 5-6
6 5-7
7 5-8
8 5-7-8
9 5-6-8
10 5-6-7
11
12
13
14 5-9
15 1-10
VDPLW108
Description
BLUE
MACROS
STROBE
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator is
simply an XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into
the XLR output socket of the last device in the chain.
Please see illustrations.
Function
1 Red
2 Green
3 Blue
5 RGB strobe
GB strobe
RG strobe
RB strobe
Red strobe
Green strobe
Blue strobe
6 RGB fade in and out
7 RGB chase
8 Manual activation (control via potentiometer)
Sound activation (the light changes to the rhythm)
DMX control
From To Function
0 255 From 0 to 100%, if no macro is on
0 4 No function
5 84 16 colours fixed
85 169 Colour changes with adjustable speed
170 255 Colour fade in and out
0 255 For slow to fast
5
Speed
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
4-3-2-1 on
HQPOWER