Guide Rails And Clamps; Fine Adjustment Of The Plunge Saw On The Guide Rail; Connecting Rods For The Guide Rails - Westfalia TSC110 Betriebsanleitung

Guide Rails and Clamps (Optional)
The guide rails allow precise and clean
straight cuts, mitre cuts and fitting. The
rails also protect the work piece surface
from damages.
Fixing with the clamps ensures solid grip
and safe work.
1. Place the guide rail on the work piece
and fix the guide rail with the clamps.
Slide the bar into the groove of the guide rail and tighten the clamp with the
lever.
Note: Place the guide rail with the black foam strips on the work piece.
2. Place the plunge saw on the guide rail. The base plate has a groove (10),
which exactly fits into the guide ridge of the rail.
Fine Adjustment of the Plunge Saw Play on the Guide Rail
The play of the base plate on the guide rail can be reduced to minimum with
the fine adjustment screws (5).
1. Loosen the fine adjustment screws by turning counter clockwise.
2. Turn both fine adjustment screws (5) clockwise to minimize the play
between base plate and guide rail, if necessary.
3. Fasten the fine adjustment screws by turning clockwise.

Connecting Rods for the Guide Rails

1. To connect both guide rails slide the
first connecting rod from the bottom into
the groove of the guide rail.
2. Slide the other connecting rod into the
second groove.
3. Use the 3 mm hex key to tighten the stud screws to the limit stop to
connect the rails.
All manuals and user guides at all-guides.com
Operation
27