Inhaltsverzeichnis
Werbung
• With the correct forward speed you prevent overheating of the saw blade,
and melting when cutting plastics.
Making Straight Cuts (90°-Cut)
1. Set the desired plunge depth.
2. To switch on the saw press the safety button (2b) and the ON/OFF switch
(2a). Press the locking switch (1) and push the motor down. Guide the saw
forward to cut.
Making Plunge Cuts
1. Set the desired plunge depth.
2. To switch on the saw press the safety button (2b) and the ON/OFF switch
(2a). Press the locking switch (1) and push the motor down. Guide the saw
forward to cut.
Note: To prevent the saw from kicking back during plunge cuts follow these
steps:
• Always place the plunge saw with the rear edge of the base plate (4)
against a fixed limit stop.
• Hold the plunge saw in both hands and slowly lower the saw blade.
Changing the Saw Blade
Before any maintenance work always switch off the plunge saw and discon-
nect from mains power!
1. Press the switch lock (1) down and push the motor down.
2. Press and hold the shaft lock (12) down.
3. Use a 5 mm hex key to turn the screw (16) at the saw blade slightly
clockwise or counter clockwise until the spindle clicks into place.
4. Use the hex key to loosen the screw counter-clockwise. Remove the outer
flange and the saw blade.
5. Clean both flanges and replace the saw blade.
Note: The rotation direction arrows of saw blade and saw must correspond!
6. Press and hold the shaft lock and tighten the screw.
All manuals and user guides at all-guides.com
Operation
26
Werbung
Inhaltsverzeichnis
