Bosch Rexroth SD301 Bedienungsanleitung Seite 36

36/144 Bosch Rexroth AG
5 Menus when connecting the SD301 to a SE31x/SEH312
5.1.4 Graph
This menu item contains the Only NOK and
All menu options (Fig. 11).
Fig. 11:
Selecting Only NOK generates the graph for
an NOK tightening job only. Selecting All
generates a graph for all tightening jobs (OK
or NOK tightening cases). The displayed
graph is updated continuously.
The standard setting displays torque (T)
above angle of turn (A).
The program number, step number for the
last step run, torque, angle of turn, total time,
and OK/NOK evaluation are displayed above
the graph. The >> and STOP buttons are dis-
played on the right (Fig. 12).
Fig. 12:
Pressing the >> button stops the graph from
updating and opens a menu which allows you
to change the graph type (Fig. 12). Selecting
SD301 | 3 609 929 826/06.03
Tred - t and Tred - A is only possible if a re-
dundancy transducer has been configured
beforehand.
Pressing the STOP button "freezes" the cur-
rent graph – the graph stops updating and
the (zoom) and 100 % buttons are dis-
played. The STOP button is displayed in-
versely.
Pressing the button subdivides the ab-
scissa (Fig. 13).
Fig. 13:
Pressing two subdivisions defines the area to
be enlarged. The selected subdivisions are
displayed inversely. Pressing the second
subdivision starts enlarging the defined area
(Fig. 14).
Fig. 14:
Pressing the button again hides the sub-
divisions.
Pressing the 100 % button restores the orig-
inal graph. Pressing the STOP button contin-
ues to update the graph.