Connecting Circuit Board A2 - Bosch 1 687 011 538 Montageanleitung

en | 16 | 1 687 011 538
 17: Jumper JP1
12. Fasten the rear cover over the terminals
13. Fasten the internal cover over the terminals
(3) .
14. Attach the connecting cable with the RJ45 plug (see
scope of delivery)  18 (2)
on the frequency inverter.
 18: Attaching the RJ45 connecting cable
15. Guide the other end of the connecting cable with
the RJ45 plug around the frequency converter and
through the opening below the display to circuit
board A2 (see  19 ).
1 689 978 635 | 2019-01-01
 18
to the RJ45 port  18 (1)
 19: Laying the cables
16. Close the cover over the terminals
17. Lock the electrical cabinet lock
18. Close the cover  10 (1).
---Separator---
2.7

Connecting circuit board A2

1. Attach the connecting cable with the RJ45 plug
 20 (1) to connection X12 on circuit board A2.
2. Connect connection X29 on circuit board A2 to
connection X29 on circuit board A1 via ribbon cable
 20 (3) .
— Pay attention to the connector coding when
attaching them.
3. Using a single-wire connecting cable, connect
connection X30 on circuit board A2
connection X30 on circuit board A1.
 20: Connecting circuit board A2
4. Hot-glue the green plug on the single-wire
connecting cable to circuit board A1
 10 (3).
 10 (2) .
 20 (2) to
( 21 ).
Robert Bosch GmbH