Saw Chain; Fix The Extension Cord; Led; Start-Up - Westfalia GM 2500/45 TS Originalanleitung

tree) and let the chainsaw run. If an increasing trace of oil appears
during this process, the automatic chain lubrication works properly.

Saw Chain

▪
Only use sharp chains. Dull chains can easily get jammed.
▪
The service life of a saw chain mainly depends on enough
lubrication and correct tensioning.
▪
Since the saw chain heats up by sawing and thereby changes its
length, check the chain tension and regulate it if necessary. This is
especially necessary for new saw chains.
▪
Do not tension a hot chain. After cooling down, the chain may
shorten and become over tensioned. After finishing work, relax the
saw chain.

Fix the Extension Cord

First, form a loop into the cord and slide the
loop through the opening of the handle in
order to fix the extension cord into the plastic
hook. By doing this, you will avoid an
accidental cut-off from power mains while
working with the chain saw.

LED

When the yellow LED turns on, the saw chain is
ready for operation.
The green LED turns on during work.
When the red LED turns on, the chain saw is
overloaded.
When the LED does not turn on after connecting
to power mains, the chain brake is activated.

Start-up

1. After mounting the chain saw and checking the oil level, connect
the plug with power mains. The LED turn on yellow.
Operation
31