Safety Instructions; Risk Of Crushing; Danger Of Tripping - Bosch ACC 200 Originalbetriebsanleitung

Use of the product constitutes acceptance of the fol-
lowing conditions:
Copyright
The enclosed instructions are the property of Robert Bosch GmbH
or its suppliers and are protected against reproduction
by copyright laws, international agreements and other
national legal stipulations. The reproduction or disposal
of instructions or excerpts thereof is impermissible and
constitutes an offence. In the event of contravention,
Robert Bosch GmbH reserves the right to take legal action and as-
sert claims for damages.
Warranty
The use of non-approved hardware causes changes to
our products and thus results in the exclusion of any
liability and warranty claims, even if the hardware has
been removed again in the meantime.
It is not permissible to make any changes to our
products and these are only to be used together with
genuine accessories and genuine replacement parts.
Otherwise any warranty claims will be invalid.
Liability
Liability on the part of Robert Bosch GmbH is limited to the amount
actually paid by the customer for the product con-
cerned. This exemption from liability does not apply to
wilful damage or damage arising from gross negligence
on the part of Robert Bosch GmbH.
FIAT AG
Safety Instructions | ACC 200 | 19
3.

Safety Instructions

Safety measures:
¶
The operator is to place the warning "Warning of
Laser beam " at eye level and in a visible manner at
the measuring station.
¶
Do not look directly into laser source.
¶
The operator must comply with the intended use.
Use protective boots!
When performing work with risk of injury to the feet, no-
tice must be given of the necessary wearing of protective
shoes. Foot injuries can, for example, be caused by falling
over or falling tools or work items, trapping the foot, oc-
currence of nails or metal shavings in the soles, etc.
Safety measures:
R
The operator is to place the mandatory sign "Use Safety
Shoes " at eye level and in a clearly visible manner at
the measuring station.
R
Operators should always wear the recommended
protective shoes.
3.1

Risk of crushing

Risk of crushing – danger from unlatched
ACC 200 or falling mirror unit!
With an improper attachment ACC 200 or on a
height adjustment of the mirror, a risk of crush-
ing either hands or feet exists.
¶
PlaceACC 200on a level surface.
¶
2 manual units for the height adjustment of
the mirror.
3.2

Danger of tripping

Danger of tripping....danger from protruding
rails!
Heightened danger of tripping exists with test
and installation work.
¶
Place specific marking and warning signs in
the working area.
en
|
1 689 989 226 2019-07-24