Bosch Rexroth PRC 7 00-L Serie Bedienungsanleitung Seite 38

38/39 Bosch Rexroth AG
Input/output array
No. PRC7000 Inputs
1 Not used
2 StateQueryTip
AckTipDressed
3
AckTipChanged
4
ResetErrorReweld_1
5
ResetErrorReweld_2
6
ResetErrorSetEndOfSequence
7
ExternalWeldOff
8
GunResistanceCalibration
9
R911415883 | PRC 7x00-Lx/Wx-0130
Description
Without function
After setting this input, the inputs of the spot selection (No.
24 - 47) are interpreted as electrode number. The status of
the single tip is displayed on the status outputs.
Feedback signal for dressed electrode
With a rising edge on this signal, wearcounter for Tip 1 will
be reset, dresscounter and dressercounter for the Tip
selected by spot selection will be counted up.
Feedback signal for changed electrode
With a rising edge on this signal, wearcounter and
dresscounter for the Tip selected by spot selection will will be
reset.
This signal is used to attempt to reset a pending error
message.
If the system is error-free, the error status of the system is
reset.
If the "Program start" input is still present, a process
repetition is started.
if the last welding process was faulty (FK not set).
The repetition parameters are selected depending on the
welding error and the error configuration.
This signal is used to attempt to reset a pending error
message.
If the system is error-free, the error status of the system is
reset.
If the "Program start" input is still present, a process
repetition is started.
if the last welding process was faulty (FK not set).
The repetition parameters are selected depending on the
welding error and the error configuration.
It is equal to ResetErrorReweld_1
This signal is used to attempt to reset a pending error
message.
If the system is error-free, the error status of the system is
reset. No process repetition is started.
The output weld complete is only set when the "Program
start" signal is present and the welding cycle is not active.
This signal is used to indicate to the controller that the next
welding cycle is to be performed without current.
Rising edge starts a special weld-job (weld-program) for