Cleaning The Condenser - Polar GL180 Bedienungsanleitung

EN
Refrigerating tips:
• Condensation and ice will form with frequent and prolonged opening of the doors.
• Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and internal/external condensation. If external condensation occurs wipe
the surface down with a cloth.
• Excessive ice will result in longer running times that will increase energy consumption and increase
the deterioration of components.
• If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency,
replace gasket.
Stainless Steel Care
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
• Use abrasive Scourers or scrubbing pads, etc.
• Use Chlorinated or acidic detergents
• Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary,
clean them off right away.
• Allow the surface to remain wet.
Do:
• Clean often.
• Use soft Cloths or plastic Scourers.
• Rub with the grain of the metal, rather than across it.
• Use detergents and polish designed for cleaning Stainless Steel.
• Ensure that the cleaning products are washed off fully and that the steel is left dry.

Cleaning the Condenser

• The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
• Always disconnect power supply before carrying
out Routine Maintenance.
• Failure to clean the condenser will reduce the
performance and life of your Polar unit and may
invalidate your warranty.
• The condenser is located above the refrigeration
cabinet. These models have a removable filter
which can be cleaned with a vacuum cleaner.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
6
GL180-GL181_ML_A5_v7_20230427.indb 6 GL180-GL181_ML_A5_v7_20230427.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
2023/4/27 13:56 2023/4/27 13:56