Cleaning, Care & Maintenance; Auto Defrost - Polar GE819 Bedienungsanleitung

Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
•
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• If left unused for any length of time, store the appliance with the door ajar.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and internal/external condensation. If external condensation occurs wipe the
surface down with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase the
deterioration of components.
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency,
replace gasket.

Auto Defrost

Periodically the appliance will run an automatic defrost cycle to prevent any ice build-up.
Note: In case of Ice built-up (3-5mm thick), set the thermostat to "OFF" and leave the door open. Then
manually defrost the appliance. Never use sharp objects for scraping.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Unit cabinet is not Temperature set incorrectly
cold enough
External environment may require
colder temperature
Door is opened too often
Door seal is worn
Door will not close Appliance is not level
properly
Door has been reversed and not
properly fitted
Shelves are out of position
Door seal is dirty
The appliance is Loose nut/screw
noisy
The appliance has not been installed
in a level or stable position
GE819_ML_A5_v2_20230605.indb 5 GE819_ML_A5_v2_20230605.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Replace the door seal
Check installation position and change if
necessary
See "Reversing the Door"
Check shelves are properly inserted
Wipe clean with a damp cloth
Check and tighten all nuts and screws
Check installation position and change if
necessary
EN
5
2023/6/5 11:36 2023/6/5 11:36