Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning, Care & Maintenance - Polar U636 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für U636:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
The appliance turns on,
but the temperature is
too high/low
U636-U638_G622_CL108-CL109_ML_A5_v4_20221208.indb 5
U636-U638_G622_CL108-CL109_ML_A5_v4_20221208.indb 5
buttons to display the
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Condensation and ice will form with frequent and
prolonged opening of the doors.
Operating outside of the recommend temperature
range and placing next to a heat source will also
increase the amount of ice and condensation.
Excessive ice will result in longer running times
that will increase energy consumption and increase
the deterioration of components.
Cleaning the Condenser Filter
The condenser is part of the refrigeration
system. The condenser filter requires monthly
cleaning.
Always disconnect power supply before
carrying out Routine Maintenance.
Failure to clean the condenser filter will reduce
the performance and life of your Polar unit and
may invalidate your warranty.
These models have a removable filter which
can be cleaned with a vacuum cleaner.
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
EN
5
2022/12/8 10:47
2022/12/8 10:47

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

U637U638G622Cl108Cl109

Inhaltsverzeichnis