Herunterladen Inhalt Inhalt Diese Seite drucken

Manual Defrost; Cleaning, Care & Maintenance - Polar UA025 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
Operation
Storing Food
To get the best results from your POLAR appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct operating temperature.
Do not place uncovered items as below inside the appliance, as this can lead to a damaged and
leaking evaporator, and thus void your warranty: hot food, hot liquids, acidic fluids, acidic products.
Wrap or cover food where possible.
Do not obstruct the fans inside the appliance.
Avoid opening the doors for prolonged periods of time.
Turn On
1. Ensure the power switch is set to [O] and turn on at the socket.
2. Switch on the Power [I]. The current temperature within the appliance is displayed.
Control Panel
For upper compartment
To unlock / Lock the keyboard press
(unlocked) / POF (locked).
Set the Operating Temperature
1. Press the SET button for 3 seconds. The display will flash.
2. Press the
or
3. Press the SET button to store the temperature.

Manual Defrost

Press and hold the defrost button "aux" for 2 seconds to begin a manual defrost. The defrost light
illuminates.
Cleaning, Care & Maintenance
Defrost appliance at least every 3 months, more often if required.
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can cut.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also
increase the amount of ice and condensation.
Excessive ice will result in longer running times that will increase energy consumption and increase the
deterioration of components.
UA025_ML_A5_v1_20221121.indb 5
UA025_ML_A5_v1_20221121.indb 5
and
together for 3 seconds. Display will flash PON
buttons to display the required temperature.
For lower compartment
EN
5
2022/11/21 16:55
2022/11/21 16:55

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis