PSI Matrix PP204 Benutzerhandbuch Seite 4

NOTES
Bedienungshandbuch
Federal
Commission
Interference Statement for United
States Users
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15B of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measure:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
1. Testing of this equipment was performed on model number PP204
or PP205.
2. The use of a nonshielded interface cable with the referenced device is
prohibited. The length of the parallel interface cable must be 3 meters
(10 feet) or less. The length of the optional serial interface cable must
be 15 meters (50 feet) or less. The length of the LAN cable must be
100 meters (330feet) or less.
3. The length of the power cord must be 2 meters (6.6 feet) or less.
Communications
Radio Frequency
i