Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LEVELLING THE WINE COOLER
ALL wine coolers must be levelled before loading with wine. Your wine cooler is equipped with four adjustable
feet to facilitate easy levelling. It is recommended that you tighten the back feet to the maximum and adjust the
front feet to level the wine cooler.
INSTALLATION INSTRUCTIONS FOR INTEGRABLE WINE COOLER:
FRONT VENTING WINE COOLER ONLY.
1. Integrable wine coolers are front venting and NOT designed to be fully integrated behind a joinery door.
2. Please follow the installation diagram when installing the wine cooler. No less than the minimum installation
dimension.
3. The wine cooler draws air from the right side of the ventilation frame and expel through the left side of the
ventilation frame under the front door.
4. The wine cooler has a power switch located on the control panel.
5. The wine cooler requires a standard 240 volt/10 A. power supply. (Or accordingly to different countries
specifications).
6. The power cord is 200 cm. in length and fixed on the right side at the back.
7. As with most appliances of today, the wine cooler has sensitive electronic components which are susceptible
to damage through lightning and electricity supply faults. It is therefore advised to use a power surge protector
to avoid problems of this nature.
In warm climate zones, an air vent or grid, with a minimum ventilation size of 200mm x 50mm MUST be cut
out at the rear top of the back cabinet or at the top of either side of the cabinet, allowing cool fresh air full
access to flow into the 30mm gap located at the rear of the cabinet.
This air vent or grid must not be open towards the same side as other appliances such as ovens. Nor can an
opening be towards an area that is sealed and without access to fresh cool air. Failing to comply with the above
specifications will result in WARRANTY void.
NOTE: The appliance must be positioned so that the outlet and plug is accessible after installation.
6
Werbung
Inhaltsverzeichnis
