Pevino PNG46SK-HHB Bedienungsanleitung Seite 15

DEFROSTING - CONDENSATION - VENTILATION
This wine cooler is designed with an "Auto-cycle" defrost system. During "Off-cycle" the refrigerated surfaces
of the wine cooler defrost automatically.
Defrost/condensation water from the storage compartment drains automatically and part of it goes into a
drainage container, which is located at the back of the wine cooler next to the compressor. The heat is
transferred from the compressor and evaporates any condensation that has collected in the container.
The wine cooler is equipped with a double-glazed door that has a third internal acrylic layer to minimize
condensation on the glass door. The wine cooler is not totally sealed; fresh air admission is permitted through
the drainpipe. Air is circulated through the cellar by means of a fan/fans and the hollow shelves.
Note: During the refrigeration cycle, heat is given off and disperses through the external surfaces of the wine cooler. Avoid touching
the surfaces during those cycles.
ADJUSTABLE WOODEN SHELVES
For easy access to the stored content, pull the shelves approximately 1/3 of its depth out of the rail
compartment. These wine cabinets, however, are designed with a notch on each side of the shelf tracks to
prevent bottles from falling.
When removing any of these shelves out of the rail compartment, tilt the shelf as per the diagram and simply
pull out, or push in the shelf until it sits on the support brackets securely.
Shelf installation and removal:
Shelf taking: According to below instruction drawing to pull out the shelf to support bracket ① , press two sides
of sliding roller buckles and pull out the shelf following the arrow mark ② .
Shelf installation: According to below instruction drawing to push in the shelf alignment with two sides of sliding
roller following the arrow mark ③ .
To prevent damaging the door gasket, make sure that the door is fully opened when pulling out the shelves.
15