Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To exit this mode, reset to 30 minutes or 24 hours, or turn the power off. When the
unit is turned back on, it will revert to the 30 minute or 24 hour auto shut off.
Industrial Alignment:
With the unit On, press and hold the Power switch and press the Accuracy
switch to change from the normal operating accuracies to the industrial
alignment accuracies. The unit will beep once and the "zero" deadband
will be entered and displayed by a flashing top and bottom arrow on the
accuracy indicators on the LCD. While in this mode, pressing the accuracy
switch will change between the 3 industrial accuracy selections. Refer to
the LCD section on page 9 for details. Press and hold the power switch
and then press the accuracy switch again to exit the industrial alignment
mode. The accuracy indicators will remain solid to confirm normal opera-
ting modes. The unit will always power up in the normal operating mode.
Liquid Crystal Display
1. Automatic Shut-Off
Clock and number indicate a 30 minute or 24 hour shut-off is
selected. No symbol indicates that auto shut-off is disabled.
2. Beeper Volume Indicator
All symbols are on when loud. Partial symbol is on
when low. No symbol indicates the beeper is off.
3. Low Battery Warning
4 indications of battery status:
Full-
Batteries OK
setup: 30 minutes
setup: 24 hours
Half-
Approximately
Initial
30 Minutes
Warning
Remaining
12
setup: loud
setup: low
Flashing-
Change
Batteries
Werbung
Inhaltsverzeichnis
