Operating Determinations - EuroLite Theatre 650 Bedienungsanleitung

Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs!
Never leave this device running unattended.

OPERATING DETERMINATIONS

This spot is a lighting effect for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
This spot is designed for professional use, e.g. on stages, in discotheques, theatres etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
spot will serve you for a long time without defects.
Do not shake the spot. Avoid brute force when installing or operating the spot.
When choosing the installation-spot, please make sure that the spot is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This spot must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the spot. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the spot is never exposed to the direct smoke jet and
is installed in a distance of 0.5 meters between smoke machine and spot. The room must only be saturated
with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This spot must only be operated in an altitude between -20 and 2000 m over NN.
Never use the spot during thunderstorms. Over voltage could destroy the spot. Always disconnect the spot
during thunderstorms.
When choosing the installation-spot, please make sure that the spot is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
- - -m
The symbol
between light-output and the illuminated surface must be more than 3 meters.
This spot is only allowed for an installation via the mounting bracket. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the spot.
The housing must never touch surrounding surfaces or objects.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
Always fix the device with an appropriate safety bond.
The maximum ambient temperature T
HEALTH HAZARD!
determines the minimum distance from lighted objects. The minimum distance
= 45° C must never be exceeded.
a
14/20 00025994.DOC, Version 2.0