Warnings And Errors; Error / Warning Acknowledgement; Reset To Factory Settings; Derating - wohner CrossMT CrossBoard Bedienungsanleitung

CrossMT Operating Instructions
Ready & Bus white, active
connected
Bus not white, blinking
connected 1 Hz
* larger numbers have higher priority

Warnings and Errors

The CrossMT has a configurable warning and fault reporting concept. Configuration can be
performed via the IO-Link interface or the ServiceTool.
Warning: Danger to life due to electric shock!
!
In the event of a device defect, the measuring adapter automatically goes into an error
state. If there is a fault in the measuring equipment, the measured values displayed
may be incorrect!

12.1 Error / Warning Acknowledgement

If a warning occurs, the connected load can continue to operate normally.
i
•
Warnings cannot be acknowledged manually.
•
As soon as the cause of a warning disappeared the warning will also disappear without
user interaction.
Important: The CrossMT does not have the option of disconnecting the load. A
!
disconnection can only be realized with an additional switching device.
•
Errors can be acknowledged via IO-Link or the Service Tool.

Reset to Factory Settings

•
It is possible to reset the device setting to factory defaults using the ServiceTool.

Derating

The maximum permissible load and auxiliary current of the device is influenced by environment
condition, mounting position and used mounted application device.
Below table lists maximum currents that are allowed in combination with CrossMT. These
values are valid for single mounting in vertical orientation and an ambient temperature of 35°C.
Page 40 of 53
Oben 2
Oben 1
36 400 000 A
English.
Revision 05/2023