Auxiliary Inputs And Outputs - wohner CrossMT CrossBoard Bedienungsanleitung

CrossMT Operating Instructions
galvanically isolated from the rest of the 24 V control circuit. The common reference point for
these signals is the GND connection.
Bild 10 Push-in connection (left) und connection tot he CrossMT (right)
•
Rigid or flexible conductors with ferrules, can be inserted directly into the terminal. (A).
•
Flexible conductors without ferrules can be inserted safely by opening the terminal
spring with the pressure release. (B).
•
To remove the conductor, the terminal spring must be opened using the pressure
release (B).
•
If necessary, use a fixture to fix the plug during connection.
•
Finally, plug the control connector into the CrossMT and fixate it by operating on the
two locking levers.

Auxiliary inputs and outputs

•
The auxiliary outputs of the CrossMT can be controlled via the IO-Link interface (see
chapter 15). In addition, the auxiliary outputs can be switched via the auxiliary inputs after
appropriate parameterization.
•
The device reacts to edge changes at the inputs. That means a change of level e.g. from
low to high at one of the auxiliary inputs causes a reaction of the device.
The CrossMT always reacts to the last detected edge change and thus has a time
!
sensitivity with regard to the inputs. It is irrelevant whether the control request is
detected via an auxiliary input or via IO-Link.
Page 38 of 53 36 400 000 A
English.
Revision 05/2023