SECU Selo-B V.2 FP Bedienungsanleitung Seite 16

Menu info / System info
• Switch on the lock using the key.
• The press .
• The "Main menu" appears.
• Scroll with the 1 or 2 key until the menu
item "Info" is highlighted.
• Confirm with .
• "Info" appears.
• Confirm with .
• Enter the administrator code to acquire
the authorisation for programming.
• The system information is displayed.
• Scroll with key 1 or 2 to view the information.
• Use the key to return.
Info / system check menu
• Switch on the lock using the key.
• The press .
• The "Main menu" appears.
• Scroll with the 1 or 2 key until the menu item
"Info" is highlighted.
• Confirm with .
• "Info" appears.
• Scroll with the 1 or 2 key until the menu item
"Systemcheck" is highlighted.
• Confirm with .
• Enter the administrator code to acquire the
authorisation for programming.
• The system check information is displayed.
• Scroll with key 1 or 2 to view the information.
• Use the key to return.
16 I Englsih
Error messages
The illustration below describes the error messages
M A I N M E N U
on the display when a fingerprint is created is or
Code change
when the safe is opened.
Language/Sprache
Administrator ...
Error message Solution
Info
Too fast! Move your finger slowly
Please repeat across the sensor.
1: FUNC:
Too tilted! Move your finger flat across
Please repeat the sensor.
Info
Too short! Move your finger across the
EE-V1.0
Please repeat sensor so that more area of
SNE:20.0A.00.00
your fingerprint can be read.
Position in the Position your finger in the
middle and repeat! middle of the sensor.
2: FUNC: M
Wrong code! Enter a valid code.
No admittance! An unsaved fingerprint has
been used. Repeat with a
fingerprint that has already
I N F O
been created.
System info
Systemcheck
1: 2: FUNC:
Technical details
Number of administrator
codes:
EE
ADC 5.45V

Number of user codes:
Flash

Touch con.
 Number of
fingerprint codes:
2: FUNC: M
Blocking times:
Power supply:
Date/time:
Updatable (firmware):
History number:
Too fast!
Please repeat
FUNC:
Wrong code!
FUNC:
No admittance!
FUNC:
1
49 (max.)
20 (max.)
After an incorrect code is entered 3x, 5 minutes,
thereafter always 10 minutes
4x AA MIGNON LR6 ALKALINE
✓
✓
2,000
Battery replacement
You can see the battery status at any time using
the battery level indicator at the top right of the
display. If the battery capacity is running low,
a corresponding message appears on the display:
When this notice appears, change the batteries
as soon as possible.
Remove the screw on the underside of the
lock electronics. This will require a Torx T 8 screw-
driver. This is included in the scope of delivery.
Let the cover slide out together with the batteries.
Remove the old batteries and dispose of them
according to the disposal instructions on page
15. Replace the batteries with four new 1.5 V AA
Mignon batteries and according to the correct
polarity. For this purpose, illustrations are shown on
the battery holder. Please use branded batteries and
no rechargeable batteries.
Push the cover and batteries back into the locking
electronics and screw them tight.
Please change
batteries!
FUNC:
SECU Selo – B V.2 FP