Overview; Putting Into Operation - Venta LW60T Bedienungsanleitung

OVERVIEW

Display
1
2 On/off switch
Evaporator compartment
3
4 Water tank
Disc stack
5
6 Water basin

PUTTING INTO OPERATION

01 08
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up.
02 Open the evaporator compartment 3 and remove the water tank 4.
03 Open the water tank 4 and fill up to the MAX marker with water.
04 Close the water tank 4 securely.
05 Insert the water tank 4 into the water basin 6 and close the evaporator
compartment 3.
Inserting the fragrance: Open the fragrance compartment 7. Twist open
06
the fragrance cap and insert it into the fragrance holder 8. Insert up to
three fragrances into the fragrance holder 8. Close the fragrance compart-
ment 7.
07 The display 1 can be adjusted to three positions.
08 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 9.
ATTENTION! The coupling of the mains cable must be plugged firmly into the
device! Please remove the protective foil for battery and remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 11.
ATTENTION! It may take about a minute for the
device to start and for the "Fill Tank" indicator in red
or yellow to be extinguished. A gurgling sound may be heard, but this does not
represent a quality defect.
13 GB
Fragrance compartment
7
8 Fragrance holder
Cable compartment
9
10 Hygiene Disc (pre-assembled)
11 Remote Control
ON/OFF
Set fan stage