Installing Without Base; Installing With Base - Joie gemm Bedienungsanleitung

i. Installing without Base
see images -
24 27
After fitting the harness to your child and determining which
rear vehicle seat location is best, you are ready to install your
infant child restraint.
1.Place the infant child restraint onto the vehicle seat where
you wish to put it. Pull the vehicle safety belt out and lock it
into the vehicle buckle, sliding the vehicle lap belt into the
side guides of the infant child restraint.
!
The child restraint can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the child
restraint securely.
24
2. Slide diagonal belt into the rear guide.
3. Pull the belt to fasten the infant child restraint tightly and
securely.
26
!
Tension the vehicle safety belt as much as possible, check
that it is not loose or twisted.
!
The vehicle safety belt shall not cause pressure on any part
of the child.
Correctly assembled vehicle safety belt is shown as
!
Lap belt must pass through the two side guides, as
!
The vehicle buckle is locked correctly, as
!
Diagonal belt must pass through the rear guide, as
ii. Installing with Base
see images -
28 34
1. Unfold the load leg from storage compartment.
11
24
-1
25
-2.
27
28
2. After placing the base on the vehicle seat, squeeze load leg
adjustment button to extend the load leg to floor
load leg indicator shows green means it is installed correctly,
red means it is installed incorrectly.
!
The load leg has 8 positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
!
Make sure the load leg is secure by pressing down on the
front of the base.3. Open the lock-off and route the vehicle
safety belt through the belt path
buckle
3. Open the lock-off and route the vehicle safety belt through
the belt path
4. Tighten the vehicle safety belt as much as possible while
pushing down on the base, and check it is not loose or
twisted.Close the lock-off.
!
Check that the safety belt does not move by pulling and
pushing hard on base. If belt loosens or lengthens, repeat
procedure.
The installed base is shown as
!
Please ensure that there is no gap between the seat and
.
the bottom of the base.
27
!
-1.
The safety belt must go under the lock-off
27
the lock-off.
5. Push the child restraint down into the base
-3.
27
restraint is secure, the child restraint indicator shows green.
If the child restraint is not secure, the indicator shows red.
!
Pull up on the child restraint to be sure it is securely
latched into the base.
!
The child restraint can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the base
securely.
6. To release the child restraint, pull the child restraint up while
squeezing the child restraint release button.
29
30
-2.
30
-1, and lock it into the buckle
30
-3
30
.
31
-2
31
-1
33
-1, the
29
-2
-1, and lock it into the
-2.
30
-1, not over
31
, if the child
32
33
34
12