Cleaning And Disinfec On Instruc Ons - Decathlon FW500 Gebrauchsanweisung

FIG. 9
Adjustment :
If needed, you can adjust the axle to eliminate any poten al altera ons between the wheel and the frame, or
to complete the release of the bu on when the wheel has been added.
If, once the wheel has been fi ed into the frame, the axle bu on isn't completely released, you need
●
to extend the usable length of the axle "L" by par ally unscrewing the "Z" nut.
● If, once the wheel has been fi ed into the frame, there's interference between the frame and wheel,
you need to extend the usable length of the axle "L" by par ally unscrewing the "Z" nut.
Note: The "Z" nut has a 1 mm thread, and consequently, the one-turn screwing includes extending or
reducing it by 1 mm / If adjus ng, it is recommended that you make successive adjustments of 1/4 turn
at a me.
7.

Cleaning and disinfec on instruc ons

ATTENTION! Use the appropriate eye/face protec on and gloves during cleaning and disinfec on
opera ons.
If the wheelchair comes into contact with blood or other bodily fluids, it must first be cleaned and disinfected,
following the instruc ons below.
Note: In most cases, it is more interes ng and more efficient to remove the seat and backrest canvas before
cleaning and disinfec ng..
Frame
Was the wheelchair with a damp cloth, using warm water and neutral soap to remove dirt or stains.
●
Wash the wheelchair again with a damp cloth to remove the detergent product.
●
Wipe down the wheelchair
●
Visually check that the wheelchair is clean
●
disinfect the wheelchair with 70-90% alcohol.
●
Make sure that the wheelchair is completely dry before proceeding.
●
Canvases
If the user is the same before and a er cleaning:
Wash, rinse and disinfect the canvases, using the same procedure as used for the frame.
●
Make sure that the canvases are completely dry before re-a aching them to the frame.
●
If the user changes a er cleaning:
We recommend replacing the canvas from the seat and backrest with new, fresh canvases.
●
FIG. 10
14
FIG. 11