Instructions To The Owner; Markings; User Maintenance Instructions - Hedson IRT UV SPOTCURE2 Bedienungsanleitung

Use IRT UV SpotCure2 at a distance of:
100 mm (4") - 300 mm (12") from object to be cured.
Curing time depends on area and material to be cured:
Closer to object >> Smaller curing area
intensity >> Shorter curing time
Further from object >> Larger curing area
intensity >> Longer curing time
Details for specific UV activated materials are individual.
See paint manufacturers data sheet, and
2. Technical data > Irradiance maps.
For larger areas, use sweeping motion similar to using a
spray gun.

5. Instructions to the owner

The owner of the curing device must produce clear
operating instructions, adapted to local site conditions,
and make these available to all users.
Only original spare parts shall be used to maintain the
products high safety.
Dispose of spent items at the nearest environmental
protection facility for recycling.
The UV radiation emission is:
according to EN62471 = Risk Group 3 (RG-3)

6. Markings

Label part no. 715419
Product identity label
715423 rev 2

7. User maintenance instructions

Storage
>> Higher
Store the IRT UV SpotCure2 indoors with an ambient
temperature of -40°C - +70°C. See other temperature
>> Lower
conditions in table in chapter 2.
Cleaning
Protective glass
Paint on front glass will significantly impair the curing
performance. Use a damp cleaning pad with water and
dishwashing solution, to clean the glass. Scrape away the
paint using a razor blade.
Note! Make sure to not get water inside the machine.
Filter
Replace the filters twice a year or when indicated in the
display:
Frequency is depending on the curing device
environment. If the filters are not clean, the IRT UV
SpotCure2 will overheat and stop.
Always change both top and bottom filters.
• Remove filters as shown below.
• Replace with new filters:See 9. Spare Parts List
Note! Correct installation of inlet filter, see image below.
Power cord
If the cable is damaged by wear or tear, it must be
replaced before use. See 9. Spare Parts
EN 7 7