Product Description; Operation And Training - Hedson IRT UV SPOTCURE2 Bedienungsanleitung

3. Product description

The IRT UV SpotCure2 is a handheld appliance with a
high power LED module emitting UV and visible light.
IRT UV SpotCure2 is available in wavelength 395 nm,
refering to the peak value.
Use products/UV paint systems developed for UV curing.
Check with your paint supplier which wavelength to use.
Overview
8
5
1. Main switch
2. Display
3. Top cover with inlet filter inside
4. Bottom cover with outlet filter inside
5. Machine sign
6. Power cord
7. Handle
8. Hook for attachment
6 6
3
2
7
6
1
4

4. Operation and training

Read all instructions before using IRT UV SpotCure2.
Before every usage, check that:
• Glass is clean and free from over spray, which decreases
the intensity.
• Fan is running during operation.
• UV LEDs light up.
• Check the cable for any signs of damage, such as cracking
and tears. If the cable is damaged by wear or tear, it must
be replaced before use.
• These products are intended only for use in a restricted
access area, or an area which incorporates suitable site
protection to prevent unintended exposure of untrained
or unqualified persons to ultraviolet radiation. It is the
responsibility of the designated parties at the final
installation site to confirm that proper installation, training,
and control means have been implemented.
Display
Timer A (top)
Timer B (center)
Adjust curing time (± 10 s.)
ON /OFF
Timer A/Timer B: Curing time in minutes and seconds.
Timer A: Set curing time
Timer B: Curing time
User instructions
Curing:
(See image "Overview"; 3.Product Description)
1. Turn main switch ON (1)
2. Set curing time (2):
+/- displayed in timer A
or
Press and hold ON/OFF for max curing time (15 minutes)
3. Press ON/OFF to start curing (2)
Turn off:
1. Press ON/OFF (2)
When the fan is no longer active:
2. Turn of the main switch (1)
Fan:
Fan is running, symbol is flashing. Keep main switch on.
EN
715423 rev 2