Introduction; Intended Use Of The Product; Technical Data - Hedson IRT UV SPOTCURE2 Bedienungsanleitung

1. Introduction

Intended use of the product

This product serves exclusively to accelerate the curing
of UV putty, filler, base and clear coats. The product
must not be used for other purposes than the described
curing processes. The maximum ambient temperature
during operation should not exceed 40°C. The UV
LED (Ultraviolet Light Emitting Diodes) equipment is
available in wavelength 395 nm.
Do not use the product in spray booths or within a
distance of 5 m from other solvent based spraying
activities in order to avoid explosion risks.
Its site of use is the preparation area and finishing
area. Within the automotive industry and vehicle repair
sectors, it is used to cure small and medium sized areas
before polishing.
UV curing
ed I=4,2A, P=115W, Vega mäter 1090mW => 450mW/cm2 Resterande värde mäter vi relativt detta dvs. (Ocean värdet/25,7)*450 mW/cm/395nm
The ultraviolet light spectrum generated by a UV LED
interacts with special coating chemistries to produce a
high-quality, durable curing. In many applications, UV
curing can achieve a faster curing and therefore also at
a lower total cost. As the UV coat contains less solvent
than conventional paint, the IRT UV SpotCure2 has less
environmentally impact.
As LEDs have a narrow wavelength band, it is important
to find the optimal wavelength for each UV putty, filler,
base- and clear coat. Please read data sheets and
discuss with the paint suppliers which wavelength is
suitable for your particular product.
Most importantly to achieve a good and fast curing result
there must be enough UV-A intensity. IRT UV radiation has
an outstanding intensity to achieve the best curing result.
Unique benefits of UV cured coating
• Reduced amount of solvent
• Fast curing time
• Low-temperature processing

2. Technical data

Wavelength nm UV LED
The IRT UV SpotCure2 is equipped with LED diods
emitting UV and visible light with a peak at 395 nm.
Efficiency decreases outside 395 nm according to graph
below.
000
000
000
000
000
000
000
0
350 400
300 350 400
Wavelength (nm)
715423 rev 2
450
450 500
Electrical data
Voltage
Frequency
Max. Current
Power
Noise level
Weight
Storage temp.
Operating temp.
Classification for indoor use I
Degree of protection
Light data
Wavelength peak
Risk Group
Light intensity
300 mm
700 mm
± Tolerances 10%
EN
IRT UV SpotCure2
100/240 VAC
50-60 Hz
2.8/1.4 A
300 W
<60 dB (A)
2 kg
-20 - +70°C
-10 - +40°C
IP 2X
IRT UV SpotCure2
395 nm
EN62471: 3 (RG-3)
Distance 100 mm
Ø 300 mm
Average 90 mW/cm²
Peak 120 mW/cm²
Distance 300 mm
Ø 700 mm
Average 14 mW/cm²
Peak 19 mW/cm²
5 5