Switching Modes; Adding And Emptying Water - Roborock WD1S1A Bedienungsanleitung

Instructions for Use

Switching Modes

1. Press Change Language/Mode to switch between Auto and
MAX modes.
2. Press and hold Change Language/Mode for 3 seconds to
switch to Floor Drying mode. To return to Auto mode, press
Change Language/Mode again. The screen will display the
icon for the current mode.
Floor Drying Auto
Notes:
• Floor Drying mode is for removing clean water from wet environments such as bathrooms. It
should not be used when water depth exceeds 10mm (0.4in).
• Floor Drying mode is limited to one minute. After which, Auto mode will resume.
MAX
Stopping
When the vacuum cleaner is in use, press Power to return it to
standby mode.

Adding and Emptying Water

When the dirty tank fills up or the clean tank empties during use,
the vacuum cleaner will automatically stop operating and provide
an audio or visual prompt. Add water into the clean tank or empty
the dirty tank as required before continuing.
Clean Tank Empty
012
Dirty Tank Full