Blaupunkt FRANKFURT RCM 82 DAB Bedienungsanleitung Seite 81

Tip: this setting can be adjusted individually
for each audio source.
BAL
Adjusts the left/right balance of the audio signal.
FADER
Adjusts the audio signal of the front/rear speakers.
EQUALIZER
Activates the SOUND PRESET option or the
EQUALIZER function.
SOUND PRESET
Turns on the POP, ROCK, CLASSIC preset sounds.
This function can also be activated directly with
the EQ button (see "CAR RADIO CONTROLS").
Tip: when the sound graph is on, the
manual EQUALIZER setting has no function
and is disabled. EQUALIZER
Activates and adjusts the 14-band equalizer. This
function can also be activated directly by pressing
and holding the EQ button (see "CAR RADIO
CONTROLS").
Activate the equalizer with the ON (AN) option to
enable the adjustment of the following
frequencies from -12 to +12 dB for FRONT
(VORNE) and REAR (HINTEN):
32 Hz, 50 Hz, 90 Hz, 125 Hz, 150 Hz, 250 Hz, 550
Hz, 1 kHz, 2 kHz, 4 kHz, 8 kHz, 10 kHz, 12 kHz and
16 kHz.
In addition, in the Q- FACTOR item, you can
adjust the filter quality/drop of 1.00, 1.41 and 2.00
(a lower value means better filter quality/bigger
drop).
Tip: when the equalizer is on, the SOUND
PRESET setting has no function and is disabled.
HPF (High Pass Filter)
The split frequency (50, 63, 80, 100, 125, 160 or
200 Hz) and filter slope 6 or 12 dB) can be set
separately for the FRONT (VORNE) front speaker
channels and/or REAR (HINTEN) rear speaker
channels to cut low frequencies, e.g. if an
additional subwoofer or other channels are used
at the subwoofer output, or if the connected
speakers cannot sufficiently reproduce the lower
frequency spectrum.
LPF (Low Pass Filter)
The split frequency (50, 63, 80, 100, 125, 160 or
200 Hz) and filter slope (6 or 12 dB) can be set
separately for the FRONT (VORNE) front speaker
channels and/or REAR (HINTEN) rear speaker
channels to cut high frequencies, for example, if
only a subwoofer is connected to the respective
outputs (or to the respective preamplifier or
speaker outputs).