Blaupunkt FRANKFURT RCM 82 DAB Bedienungsanleitung Seite 76

18. Steering Wheel Remote Control (SWC)
With this car radio, you can freely assign the steering wheel
remote control buttons (if available) to existing functions in
the car radio's SWC configuration.
Storing functions
In the car radio settings, open the VARIOUS
(VERSCHIEDENES) -> SWC menu. Now, use or the
multifunction rocker switch to select the function you want
to set up, and confirm with the >> button.
The car radio will now wait for a signal from the steering
wheel remote control, and display PRESS BUTTON AT
STEERING WHEEL FOR 1SEC (TASTE FUER 1 SECOND
DRUECKEN). Press a desired button on the steering wheel
remote control.
If the button has been successfully set up, the display will
show OK. Repeat the procedure if the unit displays FAIL
(FEHLER) or does not respond at all. Repeat this step for all
buttons to be set up.
Tip: if storing is not possible even after several attempts
or is not performed correctly, check the radio connections
or the compatibility of the interface used. If FAIL
(FEHLER) is always displayed, the error is probably in the
remote control or in the interface. If the radio does not
respond at all, make sure that the remote
control/interface is (properly) connected.
Tip: the programmable SWC interface of the radio
includes analogue steering wheel presets. The car radio
works with analogue remote controls that control
functions through different resistance values (resistance
matrix) at the connector (up to two control lines and 1x
GND).
Some remote controls are directly compatible, others
require an SWC interface. The steering wheel remote
controls cannot be connected via CAN without an
interface.
For more information on the accessories suitable for your
vehicle, contact your specialist dealer or the vehicle
manufacturer.