Base Plate; English - DeWalt D259801 Anleitung

HAMMER TRUCK D259801
FOR USE WITH D25980
WARNING: Improper operation or
maintenance of this product could result
in serious injury and property damage.
Read and understand all warnings and
operating instructions in the pavement
breaker's instruction manual before
operating or performing maintenance on
this equipment.
WARNING: Turn off the pavement
breaker and unplug from the power
source before making any adjustments
or removing or installing attachments or
accessories.
CONTENTS (fi g. 1–3)
a. Handle
b. Strap
c. Max load 165 lbs. (75 kg) warning label
d. Handle hardware: 2 bolts, 2 nuts, 2 curved
washers
e. Base plate hardware: 2 bolts, 2 nuts, 4 flat
washers
f. Wrenches (2)
ASSEMBLY (fi g. 1–3)
Handle
Align the tubes on the handle (a) with the tubes on
the hammer truck body. Firmly push handle down to
align holes. Using the wrench supplied, secure with
handle hardware (d).

Base plate

Unfold the base plate. Using the wrench supplied,
install the base plate hardware (e). Secure the base
plate by tightening all four bolts (e, g).
Usage (Fig. 5–7)
1. Remove hook (h).
2. Place pavement breaker (i) onto hammer truck.
NOTE: If bit is attached, place bit in the base
plate groove (j). If the bit is not attached, pull
up on knob (k), move base plate peg (l) into
the center position and release knob. Place
pavement breaker on base plate peg.
3. Replace hook (h). Adjust the strap (b) to the
desired height by moving the hook (h) and loop
(m) up and down.
4. Secure pavement breaker to hammer truck by
tightening strap (b).
5. Wrap power cord around the quick-release cord
wrap levers (n).
QUICK-RELEASE CORD WRAP (FIG. 6)
Pull one or both of the quick-release cord wrap
levers (n) and rotate the levers to release the cord
wrap.
Transporting
WARNING: Risk of unsafe operation.
Ensure proper footing and use caution
when rolling hammer truck so it does
not tip or cause loss of balance.
WARNING: Risk of unsafe operation.
Do not exceed load limit of 165 lbs.
(75 kg). Personal injury may result.
Refer to warning label (c).
CAUTION: Risk of unsafe operation. Do
not transport unsecured tool. Personal
injury may result.
1. With pavement breaker (i) secured, grasp
handle (a) and slowly tilt hammer truck back so
it can be rolled on the tyres.
2. When location is reached, slowly lower hammer
truck to rest on base plate.

ENGLISH

3