Troubleshooting; Warranty Information - Albrecht Tectalk Float 2 Anleitung

10. Troubleshooting

The unit does not switch on or switches off
automatically.
I cannot communicate with other members.
You can hear the other participant, but they
cannot hear you.
Other participants will only hear you interrupted. 1. the signal is too weak - they are too far apart.
I hear radio calls from other groups.

11. Warranty information

We are obliged to enclose with each appliance information on disposal, on the statutory warranty
provisions and the EU declarations of conformity with instructions on the use of the appliances in the
various countries.
You will therefore find this information in the following text.
Statutory warranty of 2 years from date of purchase
The seller of this device grants you a statutory warranty of two years from the date of purchase of
the device. This warranty covers all faults that should occur due to defective components or faulty
functions within the warranty period, but not faults that are based on normal wear and tear, such as
used batteries, scratches in the display, housing defects, broken antennas, as well as defects due
to external influences, such as corrosion, overvoltage due to improper external power supply or use
of unsuitable accessories. Defects caused by improper use of the unit are also excluded from the
warranty.
If you have a warranty claim, please contact the dealer from whom you purchased the unit or our
service partner directly. The dealer will either repair or replace your unit, or he will provide you with a
service address specialised for the unit.
If you send in your unit, do not forget your purchase receipt as proof of the date of purchase and
please describe the fault that has occurred as precisely as possible.
1. charge the batteries or insert fresh batteries.
2. are the batteries inserted correctly?
3. clean the battery contacts before charging.
1. make sure you are on the same channel and
sub-channel (CTCSS/DCS).
2. you are outside the transmission range of the
other radios.
Check that you are using the same channel as
the person you are talking to.
If the person you are talking to uses a CTCSS
or DCS code, you must also use this code to
be heard.
2. iIs the microphone defective? Please contact
a specialist dealer.
Other users are using the same channel as you
- change the channel.
19