Bluetooth Settings; Display Calibration Settings; Device Connections; The Iso Connector - Kramer KR-737+ Handbuch

REG On/Off: Choose AF function to implement or ignore the regional code (of
•
the PI) and only stations in the current region can be tuned automatically.
10.3.8

Bluetooth settings

Please refer to the chapter of the Bluetooth functions.
10.3.9

Display calibration settings

Touch button to enter the display calibration. TS Setting: When the touch operation is
not sensitive or valid, you should calibrate the touch screen through "TS Calibrate" func-
tion. Touch the adjust entry to enter calibrating menu, and follow the screen introductions
by touching the two "+" points on the screen to
finish the calibration.

Fig. 24: Display calibration

11

Device connections

11.1

The ISO connector

1. If your car is equipped with the ISO connector, then connect the ISO connectors
as illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle
carefully before connecting, incorrect connection may cause serious damage to
the unit. Cut the connector, connect the colored leads of the power cord to the
car battery, as shown in the colour code table below for speaker and power ca-
ble connections.

Fig. 25: ISO connector

Note: Please use the provided ISO connector or use DIN/ISO adapters.
Manual KR-737+ radio navigation system
30
EN