OEG SecuFresh 22 Montage- Und Bedienungsanleitung Seite 16

16
GB Content
1 Introduction
GB
1 Introduction
1.1 Intended purpose
1.2 Safety instructions
1.3 Applicable documents
1.4 Delivery and transport
2 Layout - scope of delivery
3 Technical data
3.1 General data
3.2 Dimensions / required space
3.3 Pressure loss /
Pump characteristic
3.4 Corrosion protection
Calcification protection
3.5
4 Assembly
4.1 Wall mounting
4.2 Storage tank installation
with accessories
This manual describes the installation of SecuFresh 22 and SecuFresh 29 fresh water
stations as well as their operation and maintenance.
This manual is intended for trained specialists with an adequate level of expertise in
handling heating systems, water pipe installations and electrical installations.
The installation and commissioning procedures should only be carried out by qualified,
specialist personnel. The fresh water stations must only be installed and operated in
frost-protected, dry areas.
Read this manual carefully before starting any installation work.
Non-compliance will void all claims on guarantee and warranty.
Illustrations are symbolic and may differ from product to product.
Subject to technical changes and errors.
This installation and operating manual must not be reproduced or made available
to third parties without prior written consent (section 2 German Copyright Act,
section 823 Civil Code).
SecuFresh 22 and SecuFresh 29 Frischwasserstation
16 4.3 Hydraulic connection
with accessories
17
4.4 Electrical connection
17
5 Start-up
17
5.1 Leak-testing and filling
17
the system
18
5.2 Initial start-up
19
6 Operation
19
Control unit
6.1
19
6.2 Gravity brake
20
6.3 Flow switch
7 Malfunctions /
20
troubleshooting
21
8 Maintenance / service
21
9 Decommissioning
21
10 Pump information
22
23
24
25
25
25
26
26
26
26
27
27
28
28