Maintenance - Kress KC100 Serie Bedienungsanleitung

the middle of the shaft with the cutting head
to the rear and make sure that your machine is
parallel to the ground.
3. When transporting your trimmer in a vehicle,
secure and position it to prevent movement or
damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.

MAINTENANCE

WARNING! Always remove battery before
conducting any maintenance on the
trimmer.
Replacing the trimmer head (See Fig. I)
WARNING! Use of wire or metal-reinforced
line is not authorized and could be
extremely dangerous. Use only the cutting line
EN
recommended in this manual, in combination
with the recommended debris guard.
WARNING! A damaged or loose cutting
attachment head may vibrate, crack, break
or come off the trimmer, which may result in
serious or fatal injury or property damage. Make
sure the trimmer head are properly and securely
tightened and in good condition before starting
work.
I
1. Insert the hex key into the hole and rotate the
trimmer head until it stops in a locked position.
2. Then, rotate clockwise to remove it, and
counterclockwise to assemble it.
Winding the line (See Fig. J1, J2, J3)
1. Rotate the spool cap to make two triangle icons
12
aligned. (See Fig. J1)
J1
J2
2. Insert the replacement line through the eyelet
(Line In) and feed it out through the other eyelet.
Ensure both ends of the line are even on each
end of the trimmer head (recommended 4.5 m
(15 ft)) and cut the line. (See Fig. J2)
3. Turn the dial clockwise to wind the line around
the spool until about 16 cm (6'') remains on either
side. (See Fig. J3)
J3
Lubricating the gearbox (See Fig. K1, K2)
1. Remove the screw on the gearbox.
2. If there is no bevel gear grease on the end of the
screw, squeeze 5 g of the gear grease (SHELL
4.5 m
(15 ft)
4.5 m
(15 ft)