Assembly & Operation; Before Operation - Kress Commercial KC150 Bedienungsanleitung

SYMBOLS
EN
8
To reduce the risk of injury,
user must read instruction
manual
Wear ear and eye protection
Direction of edger blade
rotation
Keep bystanders at a safe
distance
Thrown objects
Rotating cutting blade
Waste electrical products
must not be disposed of with
household waste. Please
recycle where facilities
exist. Check with your local
authorities or retailer for
recycling advice.
Li-Ion battery This product
has been marked with a
symbol relating to 'separate
collection' for all battery
packs and battery pack.
It will then be recycled
or dismantled in order to
reduce the impact on the
environment. Battery packs
can be hazardous for the
environment and for human
health since they contain
hazardous substances.
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Wear protective gloves
Remove battery from the
socket before carrying out
any adjustment, servicing or
maintenance.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.

BEFORE OPERATION:

Assembling the Front Handle (See Fig. A1,
A2)
A1
A2
1. Remove the tape.
2. Attach the Front Handle and lower clamp on the
shaft.
3. Put the bolt through the holes.
4. Tighten the Front Handle.
WARNING: Adjust the Front Handle as
desired so as to make sure your front arm is
straight when using the edger.