Kress Commercial KC150 Bedienungsanleitung Seite 10

C3
Testing the edger and battery (See Fig. D)
Checking the controls
Operator Presence Switch and Throttle Trigger
1. Remove the battery.
2. Try to press the Throttle Trigger. If the Throttle
Trigger can be pressed, the Operator Presence
Switch is defective. Stop using the edger and
contact the service agent.
4. Hold and press the Operator Presence Switch
first, then press the Throttle Trigger.
5. Release the Throttle Trigger and the Operator
Presence Switch. If the Throttle Trigger or the
EN
Operator Presence Switch is stuck and cannot
spring back to its original position. Stop using the
edger and contact the service agent.
Checking the display
1. Insert the battery.
2. Hold and press the On / Off Switch.
The product is switched on when the LED (a) is
lit.
The product is switched off when the LED (a) is
out.
3. Press the Operator Presence Switch first, then
press the Throttle Trigger to start the machine.
The Edger Head rotates.
4. If the warning indicator (b) lights up or is flashing,
refer to Troubleshooting for solutions.
5. Release the Throttle Trigger. The Edger Head
stops rotating after a short delay. If the Edger
Head continues to rotate, remove the battery and
contact the service agent.
10
D
OPERATION:
Starting the edger (See Fig. E1, E2)
E1
E2
1. Hold the edger firmly with your right hand on the
control handle – wrap your thumb around the
handle. Hold the edger with your left hand on the
auxiliary handle– wrap your thumb around the
handle.
2. Hold and press the On / Off Switch until the
green LED is lit. The green LED shows the power
level.
3. If the Edger is left unattended, or the operator
presence switch is not depressed, for 5 seconds,
the green LED for start/stop indication goes out
b
a