Steba VK 300 Advanced Gebrauchsanweisung Seite 18

Programmes
Select a programme
∙ Open the pressure bar.
∙ Press the sealing / programme selection button no. 10.
∙ Pressing the button changes the programme. The respective LEDs show the cur-
rently selected programme (see below).
Base programme M 0
∙ This is the most used programme with maximum vacuum
power and sealing time for corrugated vacuum bags.
Programme M 1
∙ This programme is best when small amounts of liquids
(max. 10 – 15 ml) passing through the bag. The device operates
with a vacuum of 95%.
∙ The pump sucks the air in 5 cycles and seals the bag.
∙ The sealing time depends on the thickness of the bags or if
small quantities of liquids lower the temperature of the sealing bar.
∙ If the sealing seam is sealed too much or still leaking, the
sealing time must be adjusted with the +/- buttons.
∙ After 5 times of intensive vacuuming, the device turns to E10 (Advanced-Series
shows "EA") to protect the electronics. Leave the device to cool down for about 10
minutes with pressure bar open. The display counts down the remaining time.
Programme M 2
∙ This programme includes the same function as program M 1.
∙ The vacuum power is adapted to soft products.
∙ After 5 times of intensive vacuuming, the device turns to E10
(Advanced-Series shows "EA") to protect the electronics.
Leave the device to cool down for about 10 minutes with pressure
bar open. The display counts down the remaining time.
18