Instar IN-8401 2K+ Bedienungsanleitung Seite 25

1 - Photosensor
2 - Infrared LEDs
3 - Lens
4 - Microphone
5 - PIR Detector
6 - Status LEDs
7 - Speaker
8 - Antenna
9 - Camera Label
10 - WPS / Reset
11 - MicroSD Card Slot
12 - Mounting Thread /
Bracket
13 - Power Connector
14 - Network Port
15 - Screw Lock
16 - Built-in Magnet
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Off
Go to https://install.instar.com
Twilight switch for IR LEDs
6 IR LEDs (invisible 940nm) and 4 IR LEDs (slightly red visible
850nm)
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
For noise detection / audio rec. / two-way audio intercom
Integrated passive infrared (PIR) motion detector
Red: power; blue: network status (Please refer to Section 4.3)
Integrated loudspeaker
Built-in 3dB antenna
P2P ID, LAN MAC address and serial number
Three seconds for WPS WiFi setup / 20 seconds for reset
Slot for MicroSD/SDXC cards (max. 256GB)
- 32GB included inside the camera -
The bracket can be used as wall mount or ceiling mount
when connected to either one of the two mounting threads
For included 5V / 2A power supply
RJ45 LAN port / connector for Cat5e LAN cable or higher
For desk-top, wall and ceiling installation
For wall mount use together with metal mounting plate
Blue LED
Connected to WiFi
Connecting via WPS
No connection to WiFi
LED is turned off, or camera
is not plugged into power
Red LED
N/A
Camera at work
Upgrading firmware
LED is turned off, or camera
is not plugged into power
6-EN