Clean Air Optima CA-401 Bedienungsanleitung Seite 7

Cleaning of the rustproof electrostatic filter
The electrostatic steel filter must be cleaned once or twice a week depending on the indoor climate.
1. Pull the plug.
2. Take the filter out of the device like described above.
3. Take the dust away from the metal parts of the filter with a soft and humid cloth.
4. Remove tenacious dirt with a sponge and some soap.
Do never put the filter under running water.
5. Dry the filter carefully and replace it after it is well dried like described above.
Attention:
Cleaning of the ionizer rail
The UV plasma ionizer air purifier CA-401 possesses a cleaning mechanism to scrape clean the
rail of the ionizer. The scraping takes place when the electrostatic filter is taken out and put back
into the device. Normally, we advise to clean the filter once a week. In order to clean it, pull the
electrostatic filter 4-5 times out of the device and put it back.
UV Lampe
The UV lamp of the Clean Air Optima UV plasma ionizer air purifier CA-401 has up to 8'000 operating
hours = 1 year of usage 24/7. When you need to replace the lamp you can order a new one under:
https://www.cleanairoptima.com/productslist/accessoires/
Replacement of the UV lamp
The back cover of the device can be taken away by pressing on the
button located at the bottom side of the cover. The cover can then be
pulled up. The UV lamp can be taken out with a quarter turn. The new
lamp can be screwed in in the same way. Finally, put the cover back
into place.
Warning
1. Do only remove the cover if necessary.
2. The device does not work if the cover is not correctly placed.
Do never put the filter back when it is wet.
7