Stopping The Device; Trimming Techniques; Warm Start Of The Engine - Fuxtec FX-MS125 Original Bedienungsanleitung

Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01

Warm start of the engine

Place the device on a firm and flat surface.
1.
2. Switch the ON/OFF to 1.
3. Slide the choke to the "OPEN" position.
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast pull will provide a strong spark and start the
engine.
If the engine does not start, please proceed again according to "Cold starting the
engine."
30.

Stopping the device

Unlock the throttle lever. Allow the device to return to idle. Press the engine stop switch
on the handle (position 0) and wait until the machine stops. If it does not stop,
disconnect the spark plug connector in an emergency. Never leave the device
unattended while it is running.
31.

Trimming techniques

ADDITIONAL SAFETY INSTRUCTIONS
Before running your device, read notes in chapters 3 and 4 of this manual.
CAUTION
IF YOU are NOT familiar with the trimming techniques, practice with the DEVICE in the
"STOP" position (turned off).
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Never run the device slowly at the
beginning of (or during) the trimming operation.
ALWAYS MAKE AWAY DISTANCE IN THE WORKING AREA from cans, bottles, rocks, etc.
Whirling objects can cause serious injury to users or bystanders and damage the device.
If an object is accidentally knocked, immediately stop the ENGINE and check the device.
Never run the device with damaged or defective parts.
Never lift the nylon cutting head above knee height during operation.
Never run the device on a slope if there is a chance of sliding or losing stability.
RELEASING THE NYLON THREAD
57