Hints For Accessories - Fuxtec FX-MS125 Original Bedienungsanleitung

Original Bedienungsanleitung FUXTEC FX-MS125_de_en_fr_ita_es_rev01
24.

Hints for accessories

● Make sure that your product is only equipped with original accessories. Only use
the original parts that the manufacturer specifies. The use of any other
accessories or attachments may cause injury to the user and damage to the
device.
● Clean the device thoroughly, especially the fuel tank and air filter. After using the
device, remove all fuel.
● If you approach a user of the device as a spectator, carefully attract his attention
and confirm that the user will stop the device. Please do not startle or distract the
user. Otherwise, you could cause an unsafe situation.
● Never touch the nylon cutting head or metal blade when the device is running. If
it is necessary to replace the guard or cutting tool, be sure that the engine and
cutting tools have stopped.
● The engine must be OFF before you change the device's working range.
● If necessary, have the device repaired by an authorized workshop. If the device is
defective, do not continue to run it.
● Never touch hot parts such as the exhaust, ignition cables, or spark plug when
starting or operating the device.
● After the device has stopped, the exhaust pipe is still hot. Never place the device
near inflammable materials (dry grass, flammable gases or liquids, etc.).
● Pay particular attention to the fact that the ground can be slippery when
operating the device in or immediately after the rain.
● If you slip or fall to the ground, release the throttle immediately.
● Before removing the blockage, stop the device and remove the spark plug
connector. Before adjusting or repairing the device, ensure the device is stopped
and the spark plug socket is removed.
● Ensure that you do not drop the device or hit it against obstacles.
● If the device is to be stored for a more extended period, let the device cool down
first. Then drain the fuel from the fuel tank and carburettor, clean the device and
place it in a safe place.
● Carry out constant checks to ensure the safe and efficient operation of the
device. For a complete inspection, please get in touch with us.
● Keep the device away from fire or sparks.
● Be careful when using the device. There is a risk of kick-back and recoil.
● Use extreme caution when using this device with the cutting blade. A cutting blade
kick-back is a reaction that can occur when the rotating cutting blade hits an object that cannot be
cut. This contact causes the cutting blade to stop for a moment and then suddenly
repels from the hit object with accelerated force. This kick-back reaction can be
45