Operation; Installing And Removing The Attachment; Selecting A Tool; Replacing The Bit - Toro 23136 Bedienungsanleitung

Operation

Important:
For 300 series traction units, ensure
that you install the Relief Valve Kit on your traction
unit before using the breaker. Failure to install the
kit may damage your traction unit. Refer to your
Authorized Service Dealer for more information.
Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
CAUTION
Hydraulic couplers, hydraulic lines/valves,
and hydraulic fluid may be hot. If you contact
hot components, you may be burned.
• Wear gloves when disconnecting the
hydraulic couplers.
• Allow the machine to cool before touching
hydraulic components.
• Do not touch hydraulic fluid spills.

Selecting a Tool

Use the following table to choose the most suitable
tool for operation:
Tool
Chisel
Moil
Asphalt Cutter

Replacing the Bit

Removing the Bit
1. Park the machine on a level surface and engage
the parking brake (if applicable).
2. Raise the loader arms and tilt the breaker so
that it is vertical.
3. Lower the bit to the ground to push it up into the
breaker until it stops.
4. Shut off the engine and remove the key.
5. Install the cylinder locks.
6. Use a hammer and the bit pin remover to
remove the stopper plug and stopper pin.
7
Use
Use for all earth-moving
duties, excavations in narrow
trenches, stratified soil, or rock
up to medium rock.
Use to demolish rocks and
materials, not stratified rock,
up to medium hardness.
Use to cut asphalt paving,
brick walls, or turf.
Figure 3
g359140