Breaking Material; Breaking A Vertical Surface; Transport Position - Toro 23136 Bedienungsanleitung

Breaking Material

Important:
Continuously impacting the same
location for long periods of time creates high
temperatures at the tip of the bit. This could cause
the bit to lose its temper and mushroom under
impact, destroying the bit.
1. Adjust the throttle for your machine as
appropriate for breaking material:
•
For 300-series machines, use full throttle
(maximum engine speed), use low range
(turtle position) on the speed-selector
lever, and adjust the flow-divider valve to
approximately the 10 o'clock position.
•
For e-Dingo machines, change the
attachment mode to Hammer Mode.
•
For TX-series machines, use 3/4 throttle.
2. Place the breaker bit within 15 to 46 cm (6 to
18 inches) from the edge of the material to be
broken, at a 90-degree angle.
Figure 14
3. Apply downward pressure with the loader arms
until the front of the traction unit raises off the
ground about 5 cm (2 inches).
Note:
Do not engage the breaker unless the
bit is on the ground and downward pressure is
applied.
Important:
Ensure that the hydraulic
cylinders have at least 5 cm (2 inches) of
stroke; do not use the concrete breaker with
the hydraulic cylinders fully extended.
4. Engage the breaker and maintain the downward
pressure as the bit works its way into the
material being broken.
5. When the material is broken, immediately
disengage the hydraulics to stop striking the
material.

Breaking a Vertical Surface

1. Position the bit on the vertical surface in the
same manner as you would position it on a
horizontal surface.
2. Maintain pressure on the bit by driving the
traction unit forward into the vertical surface
while operating the breaker.
3. Periodically lower the breaker to a vertical
position to allow debris that may have collected
in the breaker to fall out.

Transport Position

When transporting the attachment, keep it as close
to the ground as possible, no more than 15 cm (6
inches) above the ground. Tilt it rearward.
1. No more than 15 cm (6
inches) above the ground
g359138
10
Figure 15
2. Tilt the attachment
rearward.
g359749