Toro 23136 Bedienungsanleitung Seite 10

1. Bit pin remover
2. Stopper pin
7. From the opposite side of the retainer pin plugs,
use a hammer and the bit pin remover to remove
the 2 retainer pin plugs.
Note:
Do not remove the retainer pins;
otherwise the bit may fall out.
1. Bit pin remover
8. Remove the loader arm cylinder locks.
9. Lower the loader arms and place the breaker
on wooden blocks.
10. Shut off the engine and remove the key.
11. Use the bit pin remover from underneath the
retainer pins to remove the pins.
Figure 4
3. Stopper plug
Figure 5
2. Retainer pin plug (2)
Figure 6
12. Remove the bit.
g358958
Installing the Bit
1. Ensure that the concrete breaker rests on the
ground.
2. Grease the bit and inside of the bit bushing.
g359829
1. Bit bushing
3. Insert the bit into the breaker housing.
4. Install the 2 retaining pins.
5. Use a hammer and bit pin remover to install the
stopper pin and stopper plug.
Important:
g359830
fully inserted in the housing as shown in
Figure 11.
8
Figure 7
Figure 8
2. Bit
Figure 9
Ensure that the stopper plug is
g359828
g358954
g358955