Storage; Storing The Attachment - Toro 23136 Bedienungsanleitung

Storage

Storing the Attachment

1. Park the machine on a level surface and engage
the parking brake (if applicable).
2. Place the breaker on 2 pieces of wood so that
the cylinder side is higher than the chisel holder
side.
3. Remove the attachment from the machine.
4. Wash the attachment with mild detergent and
water to remove dirt and grime.
5. Check and tighten all bolts, nuts, and screws.
Repair or replace any damaged or worn parts.
6. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
7. Remove the hex plug and spray anti-rust spray
into the piston area. Install the hex plug.
1. Hex plug
Figure 19
Figure 20
8. If the attachment will be stored for more than
30 days, release the gas pressure from the
attachment:
A. Remove the bit; refer to
(page 7)
B. Release the nitrogen gas from the cylinder
cover through the gas valve.
1. Gas valve
C. Place a drain pan under the hoses and
g359808
loosen the plugs.
1. Hose plug
D. Insert a rod into the piston, and gently push
it in using a hammer.
Note:
gas from the cushion chamber.
E. Tighten the hose plugs.
F. Grease the bit and install it; refer to
the Bit (page
9. Store the breaker in a clean, dry garage or
storage area. Cover it to protect it and keep it
g359806
clean.
10. When removing the breaker from storage,
replace the nitrogen gas before operation;
contact your Authorized Service Dealer.
14
Removing the Bit
Figure 21
Figure 22
2. Rod
This releases any excess nitrogen
8).
g359805
g359807
Installing